[. . . ] HQ 2SHUDWLQJ LQVWUXFWLRQV 6 6WDUW $ % & 5HVHW VHF en Table of contents Washing the dishes . 17 17 17 17 18 18 18 18 19 19 19 19 20 20 20 20 20 21 21 22 22 23 23 23 24 24 25 25 25 26 26 26 26 26 27 27 27 28 28 28 28 28 Safety instructions . 17 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. ­ Please dispose of the packaging material in an environmentally friendly manner. [. . . ] There is a slight increase in the energy consumption. 17 en Optical display while the programme is running * * depending on model While the programme is running, a light spot shines on the floor under the appliance door. Do not open the dishwasher door until the light point is no longer visible on the floor. If the appliance is installed at eye-level, with flush furniture front, the light point is not visible. ­ Hold down programme button # and press START button ` until : . . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. To change the setting: ­ By pressing the button 3, you can switch the function off : or on :. The following applies to TurboSpeed 20 min. : During the heating up phase the light spot on the floor is lit constantly. At the end of the heating up phase the light spot flashes, indicating that the appliance can be opened and loaded. When the appliance has been restarted and the door closed, the light spot is lit constantly again during the rinsing phase. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. ­ Press P + or ­ button until the displayed time corresponds with your requirements. ­ To delete timer programming, press the P + or ­ button until h : is indicated on the digital display. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value : is indicated on the numerical display h. ­ Hold down programme button # and press START button ` until : . . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). ­ Close the door. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display h. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). 18 en The following applies to TurboSpeed 20 min. : The programme has ended when you do not want to add another rinse cycle after the light spot on the floor has flashed and you switch off the appliance with the ON/ OFF switch (. ã=Warning Switching off automatically after the end of the programme * * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Appliance does not switch off automatically : Off after 1 min : Off after 120 min ­ Open the door. ­ Hold down programme button # and press START button ` until : . . . [. . . ] Connection to hot water is recommended if the hot water can be supplied by energetically favourable means and from a suitable installation, e. g. The hot water setting : allows you to adjust your appliance optimally to operation with hot water. It is recommended to have a water temperature (temperature of the incoming water) of at least 40 °C and no more than 60 °C. It is not recommended to connect the appliance to hot water if the water is supplied from an electric boiler. [. . . ]